Download  Print this page

Dell B2360D User Manual Page 119

Laser printer.
Hide thumbs

Advertisement

Troubleshooting
Network error, standard port [54]
Try one or more of the following:
From the printer control panel, press
Unplug the router, then wait for 30 seconds, and then plug it back again.
Turn off the printer, then wait for about 10 seconds, and then turn the printer back on.
Update the network firmware in the printer or the print server. For more information, contact technical support.
Non‑Dell [supply type], see User's Guide [33.xy]
Note: The supply type can either be a toner cartridge or imaging unit.
The printer has detected a non‑Dell supply or part installed in the printer.
Your Dell printer is designed to function best with genuine Dell supplies and parts. Use of third-party supplies or parts
may affect the performance, reliability, or life of the printer and its imaging components.
All life indicators are designed to function with Dell supplies and parts, and may deliver unpredictable results if third-
party supplies or parts are used. Imaging component usage beyond the intended life may damage your Dell printer or
associated components.
Warning—Potential Damage: Use of third-party supplies or parts can affect warranty coverage. Damage caused by
the use of third-party supplies or parts are not covered by the warranty.
To accept any and all of these risks and to proceed with the use of non-genuine supplies or parts in your printer,
press
and
on the printer control panel simultaneously for 15 seconds to clear the message and continue
printing.
If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install
a genuine Dell supply or part.
Note: For the list of supported supplies, see the "Ordering supplies" section of the User's Guide or visit
http://support.dell.com.
Paper too short [34]
Try one or more of the following:
Load the correct size of paper in the tray.
From the printer control panel, press
Check the tray length and width guides and make sure the paper is loaded properly in the tray.
Make sure the correct paper size and type are specified in Print Properties or in the Print dialog.
Make sure the paper size and type settings are specified in the Paper menu on the printer control panel.
Make sure the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, then make sure the
paper is large enough for the data being printed.
Cancel the print job.
to clear the message and continue printing.
to clear the message and print using a different tray.
119

Advertisement

Table of Contents

   Also See for Dell B2360D

   Related Manuals for Dell B2360D

This manual is also suitable for:

B2360dnB2360d-dn

Comments to this Manuals

Symbols: 0
Latest comments: