Settings - Electrolux TK SL5 E User Manual

26 electrolux
Discoloration
Changing the bulb for interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local service centre.
Important! When the appliance is switched
on, the interior lighting switches itself off after
4 minutes when the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Before replacing the bulb, disconnect
the mains plug; with a permanent con-
nection: fully unscrew or deactivate the
fuse.

SETTINGS

The special options that can be set under
SETTINGS remain permanently stored inde-
pendent of each drying cycle – even after the
appliance has been switched off or the mains
plug has been removed from the socket.
To enter the settings:
1. Press Option button repeatedly until se-
lection frame marks SETTINGS.
2. Press OK button to confirm.
3. Use Option button to scroll through the
list.
After few seconds of inaction settings view
comes back to main view.
You can get back to previous view each time
if you select Back and confirm OK.
Particularly high room tempera-
ture.
Colour fastness of textiles.
1. Unscrew cover above the bulb (this can
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gas-
ket before screwing back the door light cov-
er. Do not operate the dryer when missing o-
ring gasket on door light cover.
LANGUAGE
Language setting is always first as a default.
1. Press OK button - frame above language
2. Press Option button until you set reques-
3. Press OK to confirm.
TIME
1. Press Option button until TIME selected.
2. Press OK to confirm - hour indication
3. Press Option until you set the right hour.
4. Press OK to confirm - minutes indication
5. Press Option until you set right minutes.
6. Press OK to confirm.
BRIGHTNESS
1. Press Option button until BRIGHTNESS
2. Press OK to confirm - frame around bar
3. Press Option until you set right brightness
4. Press OK to confirm.
Automatic process, there is no
fault with the appliance. If possi-
ble, lower the room tempera-
ture.
Check colour fastness of tex-
tiles. Only treat textiles together
if they are a similar colour.
be found directly behind the loading aper-
ture, at the top; refer to "Description of
machine" section.)
Warning! For safety reasons, the cover
must be screwed down tightly. If this is
not done, the dryer must not be
operated.
abbreviation starts blinking.
ted language.
starts blinking.
starts blinking.
selected.
indicator starts blinking.
level.