Table of Contents
Advertisement
tortion to the shape of a garment
which might occur in few cases, can
be remedied by ironing.
Selecting the programme
Use the programme selector to set the pro-
gramme you require. The estimated pro-
gramme duration (in hours and minutes) ap-
pears in the multi-display as well as cycle fin-
ish time.
Select Dampfmenge (STEAM LEVEL)
To achieve the best results, different
steam levels are required for different
volumes of laundry.
The Dampfmenge (STEAM LEVEL) but-
ton is used to set the required steam
quantity of: MIN, MED or MAX.
All ProSteam programmes, apart from the
REFRESH programmes, automatically rec-
ognize the remaining dampness in clothes.
When laundry is wet, a drying cycle is acti-
vated first if required. The table shows the
steam levels appropriate for the selected
load, under Dampfmenge (STEAM LEVEL).
Press the Dampfmenge (STEAM LEVEL) but-
ton repeatedly until the desired steam level
(MIN, MED or MAX) is shown in the display.
If the Dampfmenge (STEAM LEVEL) button
is not pressed after a ProSteam programme
is selected, the medium steam level (MED) is
selected automatically. If you select a RE-
FRESH programme, MIN is selected auto-
matically.
Important! If in doubt, always select a
lower steam level first until you have
more experience with load volumes,
fabric types and the corresponding
optimum steam level. If too high steam
1) available with cotton/easy care and cotton/synthetic shirts programmes
level is selected, garments may lose
their shape. If too low steam level is
selected, creases may remain.
Selecting additional options
The additional options available for the ProS-
team programmes are LONG ANTICREASE,
BUZZER, SPIN SPEED
LOCK.
1. By turning the knob choose a ProSteam
programme.
2. To set the option press Option button.
you will see available options on the
screen.
3. Press repeatedly Option button to select
proper option. Selection is marked by
rectangular border.
4. Press OK button to activate it. Suitable
icon should appear on the right side of the
screen.
To deselect an option follow the same
steps. Option icon should disappear.
LONG ANTICREASE
A 90 minute anti-crease phase is set. The
display now shows the long anti-crease
icon. If this additional option is selected, the
anti-crease phase (30 min.) at the end of the
ProSteam cycle is lengthened by 60 minutes.
The laundry can be removed at any time dur-
ing the anti-crease phase.
BUZZER
The appliance is supplied with the BUZZER
function deactivated. The button is used to
switch the function on or off. When the func-
tion is active, the BUZZER symbol appears in
the display.
The buzzer sounds or plays a tune during:
– cycle end
– anti-crease phase and when phase starts
or ends
– cycle interruption by a warning
– alarm
CHILD LOCK
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child safety device locks all
buttons and the programme knob. The child
safety device can by deactivated by holding
electrolux 13
1)
and the CHILD
Advertisement
Table of Contents
