Drying Rack - Electrolux TK SL5 E User Manual

0:10 minutes is in the display (corre-
sponding to the cooling phase).
2. Press the Zeitwahl (TIME) button repeat-
edly until the desired programme dura-
tion is shown in the display, e.g. 0:20 for
a programme of 20 minutes.
If the programme duration is not selected,
the duration is automatically set to 10 mins.
Selecting Zeitvorwahl (DELAY START)
See chapter ProSteam system , section Se-
lecting Zeitvorwahl (DELAY START).
Starting the drying programme
Press the Start / Pause button. The pro-
gramme starts.
The progress bar and the name of currently
performed phase, above it, show stage of the
cycle.
With wet laundry, after a few minutes the ap-
pliance will show the correct programme du-
ration and foreseen time of cycle end.
It is normal for the appliance to make
noises during drying programme if gar-
ments with hard parts, such as metal
buttons, are put in the drum.
Changing a programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
Aus (OFF) and then reset the programme.
The programme can no longer be
changed directly once the pro-
gramme has started. If you never-
theless attempt to change the pro-
gramme with the programme knob
the following message is shown:
Please turn programme selector to the
last used position.
The drying programme is not how-
ever affected by this.
Putting in extra items or taking items out
before end of programme
1. Open loading door.

Drying rack

Special equipment for gentle drying washa-
ble woollens and sport shoes. Incomparable
for drying wet woollens - eliminated move-
ment, protection from matting.
Warning! Laundry and drum can
become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audi-
bly lock.
4. Press the Start / Pause button to contin-
ue the drying cycle.
Drying programme complete / removing
laundry
After the drying cycle is completed , 0:00
starts flashing and alternatively the messag-
es: Finished. Please remove the laundry and
Anti-crease appear in the display. If the buz-
zer has been activated, an audible signal
sounds at regular intervals.
The drying programme is automati-
cally followed by an anti-crease
phase, including brief steam pha-
ses, which lasts around 30 minutes.
The drum rotates during the anti-crease
phase. This keeps the laundry loose and
free of creases. It can be removed at any
time during the anti-crease phase. Laun-
dry should be removed as quickly as
possible to prevent creases from form-
ing.
1. Open the loading door to remove the
laundry.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care
and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme knob to Aus (OFF).
Important! After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container (See
chapter "Care and Cleaning".)
5. Close door.
For drying rack unpacking see Installa-
tion chapter.
electrolux 19