Table of Contents
Advertisement
The steam water tank is empty. Please fill
it and then press START.
If the steam water tank is empty when you
select a ProSteam programme the following
message will appear on the display (see pic-
ture). The programme cannot be started.
You will need to fill the water tank first (see
chapter ProSteam system - section Filling
steam water tank )
It is normal for the appliance to make
noises during a ProSteam or drying pro-
gramme if garments with hard parts,
such as metal buttons, are put in the
drum.
Changing a programme
To change a programme which has been se-
lected by mistake once the programme has
started, first turn the programme selector to
Aus (OFF) and then reset the programme.
The programme can no longer be
changed directly once the pro-
gramme has started. If you never-
theless attempt to change the pro-
gramme with the programme knob
the following message is shown:
Please turn programme selector to the
last used position.
The drying programme is not how-
ever affected by this.
Putting in extra items or taking items out
before end of programme
1. Open loading door.
Warning! Laundry and drum can
become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audi-
bly lock.
4. Press the Start / Pause button to contin-
ue the drying cycle.
ProSteam programme complete /
removing laundry
After the ProSteam cycle is completed , 0:00
starts flashing and alternatively the messag-
es: Finished. Please remove the laundry and
Anti-crease appear in the display. If the buz-
zer has been activated, an audible signal
sounds at regular intervals.
The ProSteam programme is auto-
matically followed by an anti-crease
phase, including brief steam pha-
ses, which lasts around 30 minutes.
The drum rotates during the anti-crease
phase. This keeps the laundry loose and
free of creases. It can be removed at any
time during the anti-crease phase, ex-
cept during steam injection phases (look
for Steam Injection message in the dis-
play !). Laundry should be removed as
quickly as possible.
1. Open the loading door to remove the
laundry.
2. Before removing the laundry, remove fluff
from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care
and cleaning" chapter.)
3. Remove laundry one garment at a time.
Important! To retain the effects of the
ProSteam treatment, clothes must be
removed one garment at a time during
the anti-crease phase and hung
immediately on a clothes hanger to dry
(for at least 5-15 mins, depending on
fabric and selected steam level). Do up
the buttons and tug the garment into
shape, paying particular attention to
cuffs and seams.
4. Turn the programme knob to Aus (OFF).
Important! After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container if you
do not use water recirculation system (See
chapter "Care and Cleaning".)
5. Close door.
electrolux 15
Advertisement
Table of Contents
