Table of Contents
Advertisement
Drying results unsatisfactory.
Loading door does not close.
Message on the display: Please
check if the door is closed prop-
erly and then press START.
When a button is pressed - no
reaction of the machine.
Drum light does not work.
Displayed programme time
changes erratically or stays un-
changed for a long time.
Programme inactive, massages:
The tank is full. Please empty it
and then press START or Please
empty the tank. are displayed.
Drying cycle ends shortly after
programme starts. Finished
message is displayed.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically (see „Drying cycle
complete ").
Wrong programme selected.
Lint filters clogged.
Fluff filter clogged.
Heat exchanger clogged with
lint.
Overloading of laundry.
Ventilation slots in base area
covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at instal-
lation site differs from standard
setting of machine.
Fine strainer not in place and/or
mesh filter not locked in place.
Drying protection. After the start
of the programme, the option
can no longer be set.
Programme selector in Aus
(OFF) position.
Defective light bulb.
Programme time is corrected
automatically depending on
type and volume of laundry and
level of dampness.
Condensate tank is full.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
electrolux 25
Select a different programme
the next time you dry (see "Pro-
gramme chart" chapter).
Clean lint filters.
Clean fluff filter.
Clean heat exchanger.
Observe recommended loading
volumes.
Uncover ventilation slots in base
area.
Clean inside surface of drum
and drum ribs.
Make an adjustment using the
Trockengrad (DRYNESS) func-
tion (see chapter "Drying")
Re-programme standard setting
for degree of drying (see 'Pro-
gramming options' chapter).
Install fine strainer and/or snap
large mesh filter into place.
Turn the programme knob to
Aus (OFF). Set the programme
again.
Turn programme selector to Be-
leuchtung (DRUM LIGHT) or to
any programme.
Replace light bulb (see next sec-
tion).
Automatic process; this is not a
machine fault.
Empty condensate tank, then
start programme with Start /
Pause button.
Select time programme or high-
er drying level (e.g. Schrank-
trocken (CUPBOARD DRY) in-
stead of Leichttrocken (DAMP)).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.
Advertisement
Table of Contents
