Operations During Rotary Mode; Category Selection; Direct Channel Selection; Manually Setting Channels Into Memory - Eclipse CD3200 Owner's Manual

Cd/usb multi-source receiver with bluetooth
Hide thumbs Also See for CD3200:
Table of Contents

Advertisement

How to operate the tuner with an optional XM satellite radio tuner connected (U.S.A./CANADA only)

Operations during rotary mode

Turn the [VOL] button to the left or
1
right.
Turn to the right:
Tunes to higher channels.
Turn to the left:
Tunes to lower channels.

Category selection

The channel can be selected from among
categories such as ROCK and DANCE.
Consult the XM website for the details of the
categories.
Press the [SELECT] (Up/Down)
1
button for less than one second.
The category will switch in the order
shown below each time button is
pressed.
Up:
Advances to the next category.
Down:
Returns to the previous category.

Direct channel selection

The channel can be selected by inputting the
channel directly.
Press the [MODE] button for more
1
than one second.
The mode will change to the direct
channel selection mode.
Press the [SELECT] (Right/Left)
2
button to select the channel
number.
Right:
Advances to the next number.
Left:
Returns to the previous number.
Press the [SELECT] (Up/Down)
3
button to select the channel
number to be input.
Each time the button is pressed, the
channel
number
following order.
0 ↔ 1 ↔ 2 ↔ 3 ↔ 4 ↔ 5 ↔ 6 ↔ 7 ↔
8 ↔ 9 ↔ 0 ↔
4
Press the [ENTER] button.
Reception starts.
Manually setting channels into
memory
This section covers the storing of stations in the
memory of numbered buttons.
Press the [SELECT] (Right/Left)
1
button to tune to the channel to be
stored in the memory.
Select any button, from [1] to [6],
2
and press it for more than two
seconds.
The tuned channel is now memorized
and set in the button selected. Repeat
the
procedure
manually tuned channels into memory,
in turn, for buttons [1] to [6]. These
buttons are called the preset buttons.
ATTENTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or when removing the
main unit), all channels stored in memory will
be lost. In such cases, set the channels into
memory again.
changes
in
the
to
set
additional
89
XVII

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CD3200 and is the answer not in the manual?

Questions and answers

Table of Contents