Switching The Sound Adjustment Mode; Parametric Equalizer Adjustment (Peq); Setting Preset Eq; Adjusting The Median Frequency And The Q Curve - Eclipse CD3200 Owner's Manual

Switching the sound adjustment
mode
Press the [ /MENU] button for
1
more than one second.
The Menu selection mode is activated.
Press the [SELECT] (Up/Down)
2
button to select SOUND.
3
Press the [ENTER] button.
The sound
activated.
Press the [SELECT] (Up/Down)
4
button to select a setting item.
Each time the button is pressed, the
setting item changes.
PEQ ↔ Position Sel ↔ X-Over ↔ Non-
F Phase ↔ PEQ
5
Press the [ENTER] button.
The adjustment mode is switched.
Parametric equalizer adjustment
(PEQ)
Press the [SELECT] (Up/Down)
1
button to select PEQ.
2
Press the [ENTER] button.
The PEQ setting mode is activated.
selection mode
How to operate the Sound Adjustment Mode

Setting preset EQ

Press a button from [2] to [6] while
1
the PEQ setting mode is activated.
Pressing the button allows you to
toggle through preset EQ modes as
follows:
Button Mode
[2] DEFEAT
[3] POWER
is
[4] SHARP
[5] VOCAL
[6] CUSTOM
ATTENTION
Custom EQ will be overwritten if the value for
BASS, MIDDLE and TREBLE are adjusted in
the audio control mode. (For details, Refer to
"How to operate the AUDIO CONTROL" on
page 64.)
Adjusting the median frequency and
the Q curve
Frequency level and Q curve for 3 bands (BASS,
MIDDLE and
separately. Q curve pattern can be chosen from
Narrow, Normal, MidWide or Wide for BASS,
Narrow or Normal for MIDDLE, and Normal for
TREBLE.
Press the [ENTER] button to select
1
the band to be adjusted.
Each time the button is pressed, the
band changes in the following order.
BASS →MIDDLE →TREBLE →
Patterns
No EQ adjustments
The pattern that
emphasize the bass
range.
The pattern that
emphasize the treble
range.
The pattern that
emphasize the middle
range.
Custom pattern
TREBLE) can be
XII
adjusted
69