Table of Contents
Advertisement
C C h h a a n n n n e e l l s s # # 4 4 -6 6 : : Channels 4 through 6 are used to assign the arm, disarm and panic functions to
separate buttons on the remote control. Teaching a button to Channel 4 erases all information about
that remote from memory. Any auxiliary functions that are desired will have to be reprogrammed.
Similarly, if the remote is set up to use the separate arm, disarm and panic channels and a button
from that remote is entered into channel one, the remote will be erased from memory, and the system
will only recognize the button that was entered into Channel 1.
C C h h a a n n n n e e l l # # 9 9 : : If any button from a known transmitter is programmed to Channel 9, all transmitters
will be erased from memory and the system features will revert to the default settings. This is useful
in cases where the one of the customer's transmitters is lost or stolen. This will erase any lost or
stolen transmitters from the system's memory. It can also be used to start from scratch if the trans-
mitter buttons were programmed incorrectly.
To exit the learn routine:
One long horn honk indicates that Learn Routine has been exited.
➤ ➤
Ignition is turned off.
Valet/Program button is pressed too many times.
➤
➤ ➤
More than 15 seconds elapse between steps.
28
©
2002
Directed Electronics, Inc.
Advertisement
Table of Contents
