Four-Pin Optional Sensor Harness; Red Wire; Black Wire; Blue, Green Wires - Directed Electronics AM1 Installation Manual

Hide thumbs Also See for AM1:

Table of Contents

Enlarged version

four-pin optional sensor harness

The red wire supplies constant power to the optional sensor.

The black wire supplies ground to the optional sensor.

The blue and green wires are multiplex inputs. They are both tied to the same zone.

If an input of less than 0.8 seconds is supplied to either wire the Warn-Away

response will occur. An input longer than 0.8 seconds to either wire will initiate the

triggered sequence and report zone 4. This port can be used for optional sensors such

as: the 506T—glass breakage sensor, or the 504D—field disturbance sensor.

This 2-pin black connector when removed in disarmed state from the control module will

reset the system back to allow the full set of customer settings and remove the dealer remote

from memory.

Before the unit will respond to the factory remote keyless system, it must learn the

polarity of the door lock wires. To learn the lock polarity:

N N O O T T E E : : It is important that all the INPUT signals to the control module are in the rest sta-

tus state (no activity) before entering the learn routine. Wait at least 15-seconds after the

ignition is turned OFF to begin this rountine, or the unit will be placed in Valet

mode.

Table of Contents

Show Quick Links

Table of Contents