Rapid Resume Logic; High Security Disarm; Feature Programming - Directed Electronics AM1 Installation Manual

Hide thumbs Also See for AM1:

Table of Contents

two times followed by a pause and then flash three times followed by a pause.

N N O O T T E E : : The Warn Away

response does not report on the LED.

The Long Term Event History will exit if the ignition is turned off or there is no activity

for 60-seconds.

rapid resume logic

The current state of the alarm will be stored in non-volatile memory. If power is lost

and then reconnected, the system will recall the stored state from memory (arm, dis-

arm, and Valet

mode).

If the system is armed and triggered and either the lock or unlock button on the fac-

tory remote are pressed within 5-seconds, the alarm will cease horn output. The horn

will chirp once for Arm if the lock button was pressed. The horn will chirp four times

for Disarm if the unlock button was pressed. If the lock or unlock button is used after

the 5-second period during a system alarm, the horn will silence, but the system will

remain in the armed state (there will be no horn honk).

The feature programming routine is used to access and change any of the feature set-

tings in the two menus below. The feature settings can be accessed and changed by

using one of the following:

The integrated LED/Valet

Use the Directed Electronics Bitwriter

N N O O T T E E : : If Feature Programming Lockout is set to ON, all features will be locked and

can only be accessed by using a Bitwriter

switch to enter the feature programming routine.

®.

Table of Contents

Show Quick Links

Table of Contents