Internal Programming Jumper - Directed Electronics AM1 Installation Manual
Hide thumbs
Also See for AM1:
- Owner's manual (23 pages) ,
- Owner's manual (23 pages) ,
- Installation manual (39 pages)
Table of Contents
Advertisement
internal programming jumper
A 10A fuse is used as both a fuse and a program jumper. This jumper determines the
light flash output polarity. In the (+) position, the on-board relay is enabled and the
unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-board
relay is enabled for (-) output on the WHITE wire, H1/2. To access the jumper, remove
the sliding door from on top of the control module, as shown below.
© 2003 directed electronics, inc.
FUSE/JUMPER
FUSE/JUMPER
(+) POSITION
(-) POSITION
25
Hide quick links:
Advertisement
Table of Contents
