Delta Electronics DUP-B Series User Manual page 261

Chapter 3 Creating and Editing Screens
The calculation method of the size of the alarm frequency table is as
follows:
2
Alarm Setting
Example:
If there are five alarm types, the required capacity for saving alarm data is:
2 Bytes × 5 = 10 Bytes
When Alarm Moving Sign is enabled, if a fault message is detected by HMI,
an alarm moving sign will show and run on the HMI.
Alarm Moving
Sign
3-240
Alarm Setup Dialog Box
  Actual
( ) ( )
Bytes a N b
a
Alarm Frequency Data
b Alarm Type
Enable Enable the alarm moving sign.
Determine the display position of alarm moving sign.
Position
It can be Top or Bottom.
Left
Right
Direction
Down
Set the moving points every time for the alarm moving sign.
Moving Points
The unit is Pixel and the range is between 1 ~ 50 points.
Set the interval time every time for the alarm moving sign.
Interval (ms)
The unit is ms and the range is between 50 – 3000 ms.
Background Set the background color of the alarm moving sign.
Color
File Size
Bytes
Alarm message will move from right to left
(Move to left).
Alarm message will move from left to right
(Move to right).
Alarm message will move from bottom to top
Up
(Move to Up).
Alarm message will move from top to bottom
(Move to Down).
Revision May, 2010