Delta Electronics DUP-B Series User Manual page 248

Project Name
HMI Type
Non-volatile data
location
Password
Starting Level
Insufficient password
level reminder
Buzzer ON
Revision May, 2010
General tab in Configuration option
Enter the name of the file for the project.
Select DOP-B series HMI type for
different functions and
requirements
The backup memory data (non-volatile data) can be saved in HMI
and USB disk. The user can select one of them from the Location
drop-down list. However, USB disk selection is available in some
HMI types. Therefore, it depends on which HMI the user select.
The setting of non-volatile data location is shown as the figure
below. After pressing Setting button, Retained Area dialog box will
pop up and the user can set the storage location of alarm, recipe
and history data in this dialog.
Used to set the highest priority password. There are 8 levels for
the password. Meanwhile, this password is also the protection
password for the file (project). Please note that the password
format is in hexadecimal (0 ~ F).
Used to set start-up priority. The highest level is 7 and the lowest
level is 0.。
When this check box is checked, if the priority for the element that
is not equal to or higher than the current setting,
to remind the user.
When this check box is checked, the function of Buzzer is enabled.
Chapter 3 Creating and Editing Screens
will display
3-227