Unpacking Instructions - Emerson CF710AW00 Owner's Manual

This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Tools Needed for Assembly
One Phillips head screwdriver
One 1/4" blade screwdriver
Three wire connectors (supplied).
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. Five fan blades
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One switch housing cover
h. Glass shades (3 or 4)
i. One loose parts bag containing:
1. Sixteen M5 x 6 washer
head blade screws
2. One rubber gasket
3. Two wood pendants
4. Two couplings
5. Three wire connectors
6. One clevis pin
7. One hairpin clip
8. One Phillips round
head flange screw
Install, Operate and Maintain Your Ceiling Fan
One stepladder
One wire stripper

Unpacking Instructions

Installed Wire Length
Up to 50 ft.
50-100 ft.
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 6). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan housing assembly from the
protective plastic bag. Turn the upper styrofoam
pad over and carefully place the fan motor
assembly into the recess in the pad with the top of
the motor facing up.
LOOSE
PARTS
BAG
GLASS
SHADES
(3 or 4)
SWITCH HOUSING
COVER
3
Wire Size A.W.G.
14
12
WARNING
HANGER BALL/
DOWNROD
ASSEMBLY
FAN
BLADES
FAN MOTOR
ASSEMBLY
HANGER
BRACKET
CEILING
COVER
BLADE
FLANGES