Tools Needed For Assembly - Emerson APOLLO CF3900AB01 Owner's Manual

This Manual Is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver
Three wire connectors (supplied.)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of the following size:
Unpacking and Assembly Instructions
For your convenience, check-off boxes are provided next to each step. As each step is com-
pleted, place a check mark in the box. This will insure that all steps have been completed
and will be helpful in finding your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Company. Substitution of parts or acces-
sories not designated for use with this product by
Emerson Company could result in personal injury or
property damage.
1. Open styrofoam unit containing fan. Remove top
half of styrofoam unit. Remove parts and check to
see that you have received the following:
a. Fan motor and housing assembly
b. One motor cover
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One housing switch cup
h. One loose parts bag containing:
1. One setscrew
2. One 3/16" hex wrench
3. Eleven 10-32 x 5/8" oval head screws
4. Two 1" threaded studs
5. Two 1-1/4" threaded studs
6. Four knurled knobs
7. Three wire connectors
8. Four 8-32 x 5/16" flat head screws
9. One pull chain pendant
10. One pull chain coupling
11. One hairpin clip
12. One clevis pin
13. Four lockwashers
14. Sixteen 10-32 x 3/8" pan head screws
15. Sixteen flat washers
One stepladder
One wire stripper
NOTE: Place the parts from the loose parts bags in
small containers to keep them from being lost. If
any parts are missing, contact your local retailer or
catalog outlet for replacement before proceeding.
NOTE: Fan blades are ordered separately and are
packaged in a separate carton.
4
Installed Wire Length
Up to 50 ft.
50-100 ft.
WARNING
!
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 8). If you feel
you do not have enough wiring knowledge or experi-
ence, have your fan installed by a licensed electrician.
CEILING
COVER
FOAM
PACKING
PROTECTIVE
PLASTIC BAG
FOAM
PACKING
Wire Size A.W.G.
14
12
BLADE
FLANGES
LOOSE
PARTS BAG
HANGER
HANGER BALL/
BRACKET
DOWNROD
ASSEMBLY
MOTOR AND
HOUSING ASSEMBLY
MOTOR
COVER
HOUSING
SWITCH CUP
CARTON