Tools Needed For Assembly; Unpacking Instructions - Emerson VERANDA CF552GES00 Owner's Manual

THIS FAN IS SUITABLE FOR WET LOCATIONS SUCH AS PORCHES, PATIOS, AND DECKS.
USE ONLY WITH LIGHT KITS MARKED SUITABLE FOR USE IN WET LOCATIONS.
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver
One wire stripper
Three wire connectors (supplied)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One switch housing assembly
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/4.5" downrod assembly
f. One hanger bracket
g. One coupling cover
h. Five fan blades
i. One bracket switch housing assembly
j. One loose parts bag containing:
1. Sixteen M5 x 6mm washer head
blade screws
2. One M4 x 12mm flat head screw
3. One M6 x 14mm pan head screw with
lockwasher
4. One M4 x 10mm serrated pan head
screw
5. One die-cast pendant
6. One pendant coupler
One stepladder

Unpacking Instructions

3
Installed Wire Length
Up to 50 ft.
50-100 ft.
WARNING
!
Before assembly your ceiling fan, refer to section on
proper method of wiring your fan (page 8). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
7. Three wire connectors
8. Two threaded studs
9. Two knurled knobs
10. Two lockwashers
11. One clevis pin
12. One hairpin clip
13. One balance kit
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove the fan assembly from the protective
plastic bag. Place the fan assembly into the upper
foam pad with the bottom of the motor facing up.
The upper foam pad serves as a holder for the fan
during the first stages of assembly.
LOOSE PARTS
BAG
BLADE
FLANGES
CEILING
COVER
Wire Size A.W.G.
14
12
FAN BLADES
BRACKET SWITCH
HOUSING ASSEMBLY
FAN MOTOR
ASSEMBLY
SWITCH HOUSING
ASSEMBLY
HANGER BALL/
DOWNROD ASSEMBLY
HANGER
BRACKET
COUPLING
COVER
U.L. Model No.: CF552