Connecting The Drain Hose; Connect To Power Supply - Kenmore 4885 - Rear Control High Efficiency 3.6 cu. Ft. Capacity Front Load Washer Use & Care Manual And Installation Instructions

Use and care guide
Table of Contents

Advertisement

Available languages

Available languages

CONNECTING
THE DRAIN HOSE
• The drain hose should always be properly secured.
Failure to properly secure the drain hose can result
in flooding and property damage.
• Do not install the end of the drain hose higher than
96 in. (244.8 cm) above the bottom of the washer.
• The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched,
pinched, crushed, or kinked.
Option 1: Standpipe
F
Elbow Bracket
Tie
Strap
Drain Hose
J
The elbow bracket should be installed near the end of
the drain hose. Insert the end of the drain hose into the
standpipe. Use tie strap to secure the drain hose in place.
NOTE:
• Total height of the hose end should not exceed 96 in.
(244.8 cm) from the bottom of the washer.
• The drain hose should be inserted no more than 8-12
inches into the standpipe.
Option 2: Laundry
Tub
Elbow Bracket
Option 3: Floor Drain
f
DrainHose
Floor Drain
Insertthe end of the drain hose into the floor drain.
Secure the hose to prevent it from moving.
CONNECT
TO POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz.
grounded 3-prong outlet.
Plug in the washer.
J
Laund_ Tub
Tie Strap
Drain Hose
The elbow bracket should be installed near the end of the
drain hose. Hang the end of the drain hose over the side of
the laundry tub. Use tie strap to secure the drain hose in place.
10

Hide quick links:

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 4885 - Rear Control High Efficiency 3.6 cu. Ft. Capacity Front Load Washer and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

796.4884 series796.4885 series

Table of Contents