Operating The Washer - Kenmore 4885 - Rear Control High Efficiency 3.6 cu. Ft. Capacity Front Load Washer Use & Care Manual And Installation Instructions

OPERATING THE WASHER
0 SORT LAUNDRY AND LOAD WASHER
Refer to page 15.
0 TURN ON WASHER
Press the POWER button to turn on the washer. The
lights around the Cycle Selector Knob will illuminate.
Refer to page 12.
\
.... i
0 SELECT CYCLE
Turn the Cycle Selector Knob to the desired cycle.
The display with show the preset Rinse/Wash
Temperature, Spin Speed, Soil Level, and Option
settings for that cycle. Refer to page 12.
ii i i i
@ Coldl'C_ld _NoSPin _ Light _ Off
SELECT CYCLE MODIFIERS
(Wash/Rinse, Spin Speed, Soil Level, and Cycle Signal)
Refer to page 19.
OPTIONS
i
_1 BEGIN CYCLE
Press the Cycle Selector Knob to begin the cycle.
Once the cycle has been started, pressing the Cycle
Selector Knob again will pause the washer and retain
the existing settings up to 8 minutes.
The washer will tumble the load briefly to measure its
weight. The load-sensing control will determine the
load size.
...... ==
PAUSE CYCLE
Press the Cycle Selector Knob to pause the cycle.
ADD DETERGENT
The load-sensing lights will indicate the load size so
the proper amount of detergent can be added. Refer
to page 16.
NOTE: You can add detergent prior to turning on the
washer. However, for optimum performance, use the
load-sensing function and follow the steps above.
OI SELECT CYCLE OPTIONS
(Pre Wash, Stain Cycle, Easy Spin, Extra Rinse,
My Cycle, and Delay)
Refer to page 20.
13