Connecting The Drain Hose; Connect To The Power Supply - Kenmore Elite 796.2947 Use & Care Manual

Hide thumbs Also See for Elite 796.2947:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLATION INSTRUCTIONS

CONNECTING THE DRAIN HOSE

• The drain hose should always be properly secured.
Failure to properly secure the drain hose can result in
flooding and property damage.
• The drain must be installed in accordance with any
applicable local codes and regulations.
• Make sure that the drain hose is not stretched, pinched,
crushed, or kinked.
Option 1: Standpipe
Bend the outlet end of the drain hose to form a U shape.
Inset the end of the drain hose into the drain. If the
drain is large enough for the flange on the hose to fit
inside, then do not insert the flange more than 1-2" into
the drain. Use the tie strap included with the installation
materials in the foam block in the tub to secure the
drain hose to the drain.
Cable Tie
If the water valves and drain are built into the wall,
fasten the drain hose to one of the water hoses with the
cable tie (ribbed side on inside).
35"~47"
(0.9~1.2 m)
If your drain is a standpipe, fasten the drain hose to the
standpipe with the cable tie provided.
NOTE:
• Normal height of the end of the hose should be
approximately 35"~47" (90~120 cm) from the floor.
• Do not install the end of the drain hose higher than 96"
(243.8 cm) above the bottom of the washer or more
than 60" (152.4 cm) away from the washer.
• Never seal the drain hose to the drain. If no air gap is
present, water can be siphoned out of the tub resulting
in poor wash/rinse performance or clothing damage.
Drain Line
Standpipe
35~47"
(90~120 cm)
35"~47"
(90~120 cm)
Cable Tie
Option 2: Laundry Tub
Bend the end of the drain hose to the desired shape and
support it on the edge of the laundry tub. Use a tie strap
to secure the drain hose in place.

CONNECT TO THE POWER SUPPLY

Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-prong outlet (refer to page 5).
Plug in the washer.
Improper connection of the equipment-grounding
conductor can result in risk of electric shock. Check
with a qualified electrician or service technician
if you are in doubt as to whether the appliance
is properly grounded. Do not modify the plug
provided with the appliance. If it does not fit the
outlet, have a proper outlet installed by a qualified
electrician. Failure to follow these warnings can
cause serious injury, fire, electrical shock, or death.
10
Laundry Tub
Tie Strap
Drain Hose
W
ARNING

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents