Connecting The Drain Hose; Connect To The Power Supply - Kenmore 111.2914 User And Care Manual

INSTALLATION INSTRUCTIONS

CONNECTING THE DRAIN HOSE

1. Attach drain hose to drain port. Squeeze clamp and
slide end of drain hose onto drain port and secure with
clamp.
Option 1: Laundry tub drain system
• Top of tub must be at least 86cm (34 inches) high and no
higher than 130cm (51 inches) from bottom of washer (A)
Option 2: Standpipe drain system
• Needs a 3cm minimum diameter standpipe with minimum
carry away capacity of 30 liters per minute.
• Top of tub must be at least 86cm (34 inches) high and no
higher than 130cm (51 inches) from bottom of washer (B).
Laundry Tub Standpipe
4.5"
(114 mm)
(114 mm)
2. Secure drain hose to laundry tub leg, drain standpipe,
or inlet hoses for wall standpipe with cable tie.

CONNECT TO THE POWER SUPPLY

Washer should be plugged into a 120-VAC, 60-Hz
grounded 3-pong outlet. Plug in the washer.
Improper connection of the equipment-
grounding conductor can result in risk of electric
shock. Check with a qualified electrician or
service technician if you are in doubt as to
whether the appliance is properly grounded.
Do not modify the plug provided with the
appliance. If it does not fit the outlet, have a
proper outlet installed by a qualified electrician.
Failure to follow these warnings can cause
serious injury, fire, electric shock, or death.
10
Wall
4.5"
WARNING
4.5"
(114 mm)