Cisco Octal-Port DMT ATU-C Line Card Information Manual page 18

dmt minrate-blocking
dmt minrate-blocking
To force a port not to retrain when actual bit rates fall below the values configured in the dmt bitrate
minimum command, use the dmt minrate-blocking command. To disable dmt minrate-blocking, use
the no form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
The default configuration, no dmt minrate-blocking, generates a minor alarm when the bit rates on a
DMT port violate the minimum allowed bit rates specified in the dmt bitrate minimum command
(if alarms are enabled in the DSL profile).
Command Modes
DSL profile configuration.
Command History Release
IOS 12.1(6)DA
Usage Guidelines To specify the bit rate below which a DMT port will not retrain, use the dmt bitrate
minimum command.
Examples The following example describes how to enable dmt minrate-blocking:
configure terminal
dsl-profile 8xDMT
dmt minrate-blocking
Cisco IOS Release 12.1(6)DA
18
dmt minrate-blocking
Modification
This command was introduced.
Octal-Port DMT ATU-C Line Card