Cisco Octal-Port DMT ATU-C Line Card Information Manual page 25

Octal-Port DMT ATU-C Line Card
slot
To provision a slot for a specific card type, or to change the line coding for a flexi line card, use the
slot command.
Syntax Description
slot#
cardtype
Defaults None.
Command Modes Global configuration.
Command History Release
12.0(5)DA
12.1(1)DA
12.1(6)DA
slot slot# cardtype
Modification
This command was introduced.
New card types were added.
New card types were added.
The number of the slot you want to provision. The range is 1 to 38.
The number of slots varies by chassis. The Cisco 6130 has
Note
38 slots, the Cisco 6160 has 34 slots, and the Cisco 6260 has
32 slots.
The line card type for which you want to configure the slot. The
valid card types are
ATUC-1-4DMT—4-port DMT card
•
ATUC-1-4DMT-I—4-port DMT over ISDN card
•
ATUC-4FLEXICAP—4-port flexi card configured as CAP
•
ATUC-4FLEXIDMT—4-port flexi card configured as DMT
•
ATUC-1-DMT8—8-port DMT card
•
ITUC-1-8IDSL—8-port IDSL card
•
• STUC-4-2B1Q-DIR-1—4-port SDSL card
Note Some line cards do not function in all NI-2 DSL systems.
For example, the Cisco 6100 system supports only a
dual-port CAP ATU-C line card. Consult the hardware
documentation for your DSL system to determine which line
cards it supports.
Cisco IOS Release 12.1(6)DA
slot
25