Epson Stylus C82 Service Manual page 38

EPSON Stylus C82
6. Remove CR Guide Shaft from Printer Mechanism in direction of arrow C while
taking care not to damage slots in Printer Mechanism.
7. Allow Carriage Unit to rotate in direction of arrow D and remove Carriage Unit
from Printer Mechanism.
10 Carriage Unit
<Left Side>
7 C.B.S (P4) 3x6
(6±1kgf.cm)
Bush
8
Hooks
6 Spacer
Figure 4-36. CR Guide Shaft/Carriage Unit Removal 2
8. Disconnect FFC from connector on Relay Board of Carriage Unit, then remove
Carriage Unit.
DISASSEMBLY AND ASSEMBLY
9 CR Guide Shaft
D
Slot
C
<Right Side>
2 PG lever
5 Bush
1 Spacer
Removal
Leaf
3 Direction
spring
2'
Torsion spring
4 C.B.S (P4) 3x6
67.78
(6±1kgf.cm)
Disassembly
Connector
Figure 4-37. CR Guide Shaft/Carriage Unit Removal 3
Be careful when installing the Bushings at each side of the Printer
Mechanism because the Left Bushing and Right Bushing have
different shapes. (See Figure 4-36)
Leaf Spring Installation
Leaf spring
Bush
Figure 4-38. Leaf Spring Installation
When removing or replacing the CR Guide Shaft/Carriage Unit,
the adjustments are necessary. Refer to "Chapter 5 Adjustment"
for the adjustment procedure.
Revision A
FFC
Relay Board
PG lever
38