Printhead Removal - Epson Stylus C82 Service Manual

EPSON Stylus C82
3. Remove 3 screws (C.B.P 3x8) holding the C486 PNL Board, then remove the
C486 PNL Board from the Panel Housing.
C.B.P 3x8 (6±1kgf.cm) x3
Panel Housing
Figure 4-6. Panel Housing/C486 PNL Board Removal 2

4.2.1.3 Printhead Removal

1. Remove Upper Housing. (See Section 4.2.1.1)
2. Use a pair of tweezers to push and lift one side of the Spring Cartridge at a time
from the 2 slots of the Carriage Unit, then remove the Spring Cartridge from the
Carriage Unit.
Spring Cartridge
Figure 4-7. Printhead Removal 1
DISASSEMBLY AND ASSEMBLY
C486 PNL Board
Carriage Unit
Slots
<Right Front Side>
3. Remove 2 screws (C.B.P (P4) 3x8) holding the Fastener Head, then remove the
Fastener Head in the direction of arrow A.
A
Figure 4-8. Printhead Removal 2
4. Push Carriage Lock Lever forward, then shift Carriage Unit to the left side.
5. Use the order shown below to release 4 hooks, then remove Cable Head Holder
from Carriage Unit in upward direction.
Carriage Lock Lever
Figure 4-9. Printhead Removal 3
Disassembly
Fastener Head
C.B.P (P4) 3x8 (5±1kgf.cm)
<Right Front Side>
4
Cable Head Holder
2
1
3
Revision A
28