Adding A Destination - Eclipse AVN2454 Owner's Manual

Adding a destination

After having set a destination, more destinations can be added.
In the following situations, set an additional destination.
•When setting a transit point between the present location and set destination
•When changing the set destination into a transit point and setting a new destination
Using the same method as setting a destination, touch
P64, "One-touch setting", P65, "Set from a registered point", or P65, "Set using a map
retrieval method")
1
Touch
Route
2
Touch for Destination.
Add
Select the map retrieval method
3
and display the map on which a
destination is to be set.
•See P44 and 60, "How to retrieve
maps" and "Performing operations on
a retrieved map".
•The destination can be set using a detailed map with a reduction scale smaller
than 1 mile.
ATTENTION
•Geographical points on maps representing set destinations are automatically
registered (up to 100 points) and can be used to retrieve a map when setting a
destination. When exceeding 100 points, the oldest entry is deleted every time a
new one is entered. Unnecessary points can be deleted. (See P123, "Deleting
entries from the destination archive")
•When adding a destination with a transit road (see P80 and 81) indicated, that
transit road indication may be cancelled depending on that geographical point.
•When 2 or more destinations are set,
.
Add to to add a destination. (See
Reorder appears.
75
Go to the next page