Eclipse AVN2454 Owner's Manual page 146

For reference
1. Facts to keep in mind when operating
Message
2 preferred roads have
been set. Perform
operation again after
deleting them.
No roads possible for
guidance nearby.
Perform operation
again after moving.
Unable to save
additional points.
Please delete some
points.
Unable to search for
new route.
Previous route will be
displayed.
Destination is nearby.
Please check the map.
No corresponding POI
nearby.
No corresponding POI
on route.
Position cannot be
specified in this scale.
Switching to more
detailed map.
The destination is
surrounded by the
water.
Change destination?
144
Cause
You attempted to set 3 or
more transit road
indications when
changing the route.
There are no roads
available to serve as
transit roads when
indicating one for a route
change.
You attempted to set
more than 5 destinations.
A new route could not be
found when reinitiating a
route search.
You attempted to set the
destination in a nearby
location.
There is no corresponding
POI found nearby for the
POI search in the vicinity.
There is no corresponding
POI found nearby for the
POI search along the route.
You attempted to set/register a
destination/memory point on a
map with a reduction scale of
more than 0.5 miles.
There is a river or other
body of water between
the destination and the
nearest road.
Remedy
Up to 2 transit roads can be
indicated.
Delete unnecessary transit
roads before adding a new one.
Move the map and indicate a
transit road among the roads in
the vicinity.
Up to 5 destinations can be set.
Delete unnecessary destinations
and proceed with adding new
ones. (See P79)
Route guidance will proceed
using the present route.
(Drive referring to the route
guidance.)
The destination is nearby. Refer
to the map and continue driving.
Search for the POI in another
area.
Search for the POI in another
area.
Set/register a destination/memory
point on a more detailed map (with
a reduction scale of less than 0.5
miles).
Touch , move the map
Yes
and set a destination near the
road. Touch No to set the
destination on the position
displayed.