Sewing - Duerkopp Adler 579 Operating Instructions Manual

9.5

Sewing

0
1
2
1 2
26
The sewing process can be controlled with the pedal, the hand
switches or the "RST" and "ESC" keys on the operating panel.
In automatic operation the machine moves to the new insertion position
after each sewing process (sequence mode).
In manual operation it moves to the insertion position of the current
buttonhole (sequence and single-button mode).
Sewing with the pedal
Push the pedal back.
–
The machine moves to the insertion position.
Insert the material.
–
Push the pedal forwards to position 1.
–
The clamps close.
Releasing the pedal opens them again.
0
The pedal moves to its rest position.
R
Push the pedal down to position 2
–
The sewing process is initiated.
To carry out another sewing process the pedal must be returned to
–
its starting (rest) position.
Sewing with the operating-panel keys
For the first operation after switch-on press the "RST" key if any
–
parameters have been changed or another buttonhole shape has
been selected manually.
The machine moves to its starting position and from there to the
insertion position.
If you wish the machine to move to its starting position, press the
–
"ESC" key.
Insert the material.
–
Press the "RST" key once.
–
The clamps close.
If you wish the clamps to re-open, Press the "ESC" key.
–
If you wish the sewing process to be initiated, press the "RST" key
–
again.
After the sewing process the machine returns to the insertion
position.
Removing material after sewing (subclass 579-151000)
Sever the upper gimp, pulling it a little if necessary. The material
–
can be moved on or removed.
To remove the material pass the bobbin thread and lower gimp
–
under thread clamp 2. Pull both threads from right to left along
blade 1.
The threads are severed.