Threading The Bobbin Thread - Duerkopp Adler 579 Operating Instructions Manual

3.5

Threading the bobbin thread

14
1
2
Caution: danger of injury
The bobbin thread may only be threaded with the machine switched off or in
threading mode (see "threading mode" section).
The machine must be in its final position, i.e. the hook turret with
loopers must point forwards.
Remove clamp plates (see section 3.2).
–
Swing machine up.
–
Use the threading wires in the accessory kit to thread the bobbin
–
thread as shown in the illustrations.
NB: The thread must be threaded above the thread tensioner 1 and
behind the thread-tensioning spring 2.
Leave about 25 mm of bobbin thread hanging out of the stitch hole
–
in the throat plate.
Fit the clamp plates (see section 3.2).
–