5.
Changing the cutting blocks
1
2
18
The cut length can be changed by switching cutting blocks.
Caution: danger of injury
Cutting blocks may only be switched with the machine switched off or
in the firm hold position.
Removing the cutting-block holder
Remove clamp plates (see section 3.2).
–
Press button 1.
–
Pull the cutting-block holder 2 downwards and remove.
–
Fitting the cutting-block holder
Press button 1.
–
Insert the cutting-block holder in the cutting-block mounting.
–
Release button 1.
–
Check that the cutting-block holder is firmly seated in its mounting.
–
Fit clamp plates (see section 3.2).
–