Switching On - Switching Off - Firm Hold; Switching On; Switching Off; Firm Hold - Duerkopp Adler 579 Operating Instructions Manual

8.

Switching on - Switching off - Firm hold

8.1

Switching on

8.2

Switching off

8.3

Firm hold

20
1
The sewing-drive switch 1 must be in position 1.
–
Turn on the main switch 2.
–
The Dürkopp Adler logo briefly appears.
The opening screen appears.
Turn off the main switch 2.
–
All drives and the controller are immediately disconnected from the
power supply.
Before any work is carried out on the machine it must be switched off
or the firm-hold mode activated.
Push the pedal back.
Turn switch 1 to position "0".
–
The machine is in firm-hold mode.
This message appears, flashing.
The sewing drive is disconnected from the mains.
The buttonhole blade is switched off.
To resume the sewing process proceed as follows:
–
Turn switch 1 to position "1".
After a short pause the machine is again ready for operation. The
sewing process is resumed at the point where firm hold was
activated.
If the symbol appears in reverse, firm hold was switched on before the
pedal was pushed back.
To clear proceed as follows:
Turn switch 1 to position "1".
–
Push the pedal back.
–
Turn switch 1 to position "0".
–
The machine is in firm-hold mode.
2