5.
Thread trimmer
5.1 Thread trimmer magnet
4
3
2
1
Caution: Danger of injury!
Switch off main switch.
Check and adjust thread trimmer magnet only when the button sewing
automat is switched off.
Standard checking
The magnet 3 pushes the lever 5 with the roller bolt into the thread
trimmer cam 6 by means of lever 1.
When the roller bolt is pushed in, it must have some axial clearance in
the cam.
–
Push magnet shaft 2 into the magnet and check whether there is
some clearance between the roller bolt and the thread trimmer
cam.
Correction
–
Loosen screws 4.
–
Press together magnet shaft 2 and magnet 3.
–
Then shift the magnet to the left as far as it will go.
–
Shift magnet back minimally.
–
Tighten screws 4.
–
Check whether there is some clearance between the roller bolt and
the thread trimmer cam when the roller bolt is pushed in.
6
5
3
27