Fan Installation (Usa) - Casablanca FOUR SEASONS III Instructions Manual

FOUR SEASONS
CROSSBAR MOUNTING BRACKET INSTALLATION
FOR FAN INSTALLATION OUTSIDE THE
USA GO TO PAGE 8
EXCLUDING MODELS ENDING IN 'E'
Proceed with installation as follows:
Step 1. Route the wires from the ceiling outlet box through
the crossbar mounting bracket center hole. Attach the bracket,
with ground wire and ridges down, to the ceiling fixture outlet
box with the mounting hardware included with the outlet
box.
Tighten the screws firmly by hand only, being careful not to
bend the bracket by over tightening.
CAUTION: To reduce the risk of
personal injury, use only the
mounting hardware provided with
the approved outlet box to install
the crossbar mounting bracket.
CANOPY
HATCH
Step 2. Attach the canopy to the crossbar
mounting bracket with three of the 8-32 x 2
long canopy screws and canopy lock washers.
Tighten the screw firmly by hand only.
NOTE: On sloped ceilings, align the
canopy opening towards the top or
room peak.
4
™
CEILING FAN
APPROVED
WIRING BOX
CROSSBAR
MOUNTING
BRACKET
WASHER
CANOPY HARDWARE
CANOPY LOCK WASHER (4)
CANOPY
CANOPY INSTALLATION
1
/ "
4
CANOPY LOCK
WASHER
III
CEILING
WIRING
FLAT
APPROVED
OUTLET
BOX
HARDWARE
CANOPY SCREW (4)
CANOPY
CANOPY
SCREW
RIDGE
SIDE
DOWN
GREEN
GROUND
WIRE
CROSSBAR
MOUNTING
BRACKET