Casablanca FOUR SEASONS III Instructions Manual page 6

FOUR SEASONS
CROSSBAR MOUNTING BRACKET INSTALLATION
Step 7. To hang the fan body in the canopy,
hold the fan body firmly and insert the ball
into the canopy opening. Check that no wires
were pinched. Rotate the fan body until the
slot in the nylon ball fits into the pin opposite
the canopy opening.
NOTE: The fan weight is 17 pounds.
NOTE: Independent control of the
light fixture using a W-8 requires an
additional power wire run from the
wall switch to the fan. See Page 12
for wiring.
Step 8a. Attach the fan wires to the ceiling fixture outlet
box wiring by twisting the bare ends of the wires together
and then securing with a wire nut. Test that the connection
is secure by pulling on the wire nut. Connect in this order:
Step 8b. Pull Chain or W-4 Wiring Connections
• GREEN leads from mounting plate and fan to GROUND
conductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling fixture
outlet box. Secure with wire nut.
• BLUE wire and BLACK power wire from fan to BLACK power
wire in ceiling outlet box. Secure with wire nut.
Step 8c. W-8 Wiring Connections
• GREEN leads from mounting plate and fan to GROUND
conductor of power source. Secure with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to RED wire from W-8 in ceiling
outlet box. Secure with wire nut.
• BLUE wire from fan to YELLOW wire from W-8 in ceiling
outlet box. Secure with wire nut.
NOTE: SEE PAGE 12 FOR ADDITIONAL WIRING INFORMATION.
Step 9. Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are on
opposite sides of the canopy and all wires
are clear of the canopy opening.
Step 10. Install canopy hatch with the
last canopy screw and lock washer. To do
this, tilt the fan body away from the hatch
opening.
Tighten the screws firmly by hand only.
Step 11. Straighten the fan, then check
to ensure that there is no movement
between the canopy and ceiling or Hang-
Tru ball and top support shaft.
6
HANGING THE FAN
D1
OPTION
WIRE
CANOPY ELECTRICAL CONNECTIONS
CANOPY HATCH INSTALLATION
CANOPY
HATCH
LOCK
WASHER
CANOPY
SCREW
™
III
BALL
SLOT
CAPPED BLUE D1-OPTION WIRE ON 3-SPEED ONLY
FOR INDEPENDENT W-8 LIGHT CONTROL
WIRE NUT
2 BLACK & BLUE
D1-OPTION WIRES
(WITHOUT W-8)
2 WHITE WIRES
3 GREEN WIRES
BLUE & YELLOW
WIRES
BLACK & RED
WIRES
2 WHITE WIRES
3 GREEN WIRES
PIN
PULL CHAIN OR
W-4 CONNECTIONS
W-8 CONNECTIONS
TILT THE
FAN TO
INSTALL
LAST
CANOPY
SCREW