Casablanca FOUR SEASONS III Instructions Manual page 8

LIGHT FIXTURE HaRdwaRE (not to scale)
lIghT KIT FITTer (1)
Step 13. Remove light kit fitter from carton.
Using the provided Phillips screwdriver, unscrew the three
screws from the fan and set aside.
Connect the 9-pin connector from the fan to the connector
on the light kit fitter as shown, aligning the red squares
and making sure they snap into place.
Connect the light fitter to the bottom of the fan as shown,
tucking the exposed wires into the fitter, and aligning the
screw holes. Using the three screws, attach the light kit
fitter to the fan.
Screw the two 60-Watt lightbulbs onto the light kit fitter.
Fish the pullchain through the center holes of the metal
disk of the light kit fitter. Continue to fish the pullchain
through the bowl and cap. Fit bowl and cap around the
light kit fitter.
Using the finial, attach the bowl and cap to the light kit
fitter.
Attach pullchains on light kit fitter to pullchain extenders.
Note: In compliance with US Federal Energy Regula-
tions, this ceiling fan contains a device that restricts
the light kit to a maximum of 190 watts. Exceeding
that limit or the marked limit on this product may
result in fire hazard or improper operation.
8
lIghT FIxTure InSTallaTIon
bowl (1) CaP (1) FInIal (1) 60-waTT Candelabra
bulbS (2)
SCrewS
FInIal
PullChaIn
exTenderS (2)
9-PIn ConneCTor
lIghT KIT FITTer
bowl
CaP