Sunbeam BM7800 Quantum SmartBake Instruction Booklet page 95

Program Setting Times and
Display Information
The LCD window will tell you if there is a
problem with your Quantum SmartBake.
Always use your Quantum SmartBake in
a room free of drafts. Do not use your
DISPLAY READS
"0:00" (:) flashing
"E:01" flashing
"E:02" flashing
"E:03" flashing
"E:04" flashing
"E:05" flashing
"E:08" flashing
Note: After baking a loaf of bread, it is recommended to cool the breadmaker down to room
temperature as temperatures above ambient reduce the rising height of the bread due to the
sensitivity of yeast.
You will hear a beep when:
The power is turned ON
Select a setting from the Menu
Invalid key-in
Commencement of baking cycle
Completion of bread baking process
PROBLEM
Select program setting
The baking chamber is too
hot to begin another cycle
Sensor malfunction
Sensor malfunction
CPU malfunction
Heater control malfunction
Heater control malfunction
Quantum SmartBake outdoors, near a heat
vent or in direct sunlight.
SOLUTION
Use the Menu button to
select program.
Open the lid and remove
bread pan to cool the chamber.
After the panel message disappears,
put the bread pan back into the
chamber and press START again.
Contact Customer Service on
the toll free number
1800 025 059.
Long beep
Short beep
Long beep
2 long beeps
Short and Long beeps
91