Table of Contents
Advertisement
Accessory holder installation
Item
Description
149
(149)
Tightening the screwed connections
•
7.1
Mains connection
B
Danger! Electrical hazard.
Operate saw in dry environ-
ment only.
Operate saw only on a power source
matching the following requirements
(see also "Technical specifications"):
− Outlets
properly
earthed and tested.
− Three-phase outlets with neutral
wire.
− Mains voltage and system fre-
quency conform to the voltage
and frequency shown on the
machine's rating label.
− Protection against electric shock
by a residual current device
(RCD) of 30 mA sensivity.
− Fuse protection of 16 A maximum
against short circuits.
− System impedance Z
interconnection
point
service connection) 0.35 Ohm
maximum.
3
Note:
Qty.
Position power supply cable so it
does not interfere with the work and
is not damaged.
Protect power supply cable from heat,
aggressive liquids and sharp edges.
Use only rubber-jacketed extension
cables with sufficient lead cross-sec-
tion (see "Technical specifications").
Do not pull on power supply cable to
unplug.
B
Changing the direction of rota-
tion! (three-phase motors only)
Depending on the phase sequence, it
is possible the saw blade will turn in
the wrong direction. This can lead to
the workpiece being hurled away
when attempting to make a cut. The
149
direction of rotation must therefore
be checked every time the saw is con-
nected to a different outlet. In case of
an incorrect direction of rotation, the
wiring of the outlet must be changed
by a qualified electrician:
installed,
a qualified electrician!
7.2
Installation
•
•
at the
max.
(house
8. Operation
A
Risk of injury!
This saw may only be operated
by one person at a time. Other per-
sons shall stay only at a distance to
the saw for the purpose of feeding or
removing stock.
Before starting any work, check to
see that the following are in proper
working order:
− power cable and plug;
− ON/OFF switch
− riving knife
− blade guard
− feeding aids (push stick, push
block and handle).
Use personal protection gear:
− dust respirator;
− hearing protection;
− safety goggles.
Assume proper operating position:
− at the front of the saw;
− in front of the saw;
− to the left of the line of cut;
− when working with two persons,
the other person must remain at
an adequate distance to the saw.
If the type of work requires, use the
following:
− table extension, if otherwise the
workpiece would fall off the table
after cutting;
− sliding carriage;
− dust collector.
Avoid typical operator mistakes:
− Do not attempt to stop the saw
blade by pushing the workpiece
against its side. Risk of kickback.
− Always hold the workpiece down
on the table and do not jam it.
Risk of kickback.
by
− Never cut several workpieces at
the same time – and also no bun-
dles containing several individual
pieces. Risk of personal injury if
individual pieces are caught by
the saw blade uncontrolled.
c
Drawing-in/trapping hazard!
Never cut stock to which
ropes, cords, strings, cables or wires
are attached or which contain such
materials.
8.1
Dust collector
A
Danger!
Dust of certain timber species
(e.g. beech, oak, ash) can cause can-
cer when inhaled. Use a suitable dust
collector when working in enclosed
spaces The dust collector must meet
the following requirements:
Advertisement
Table of Contents
