Operation - Elektra Beckum TKHS 315 P Operating Instructions Manual

6.1 Mains connection
B
Danger! Electrical hazard.
Operate saw in dry environ-
ment only.
Operate saw only on a power source
matching the following requirements
(see also "Technical specifications"):
Outlets properly
earthed and tested.
Three-phase outlets with neutral
wire.
Mains voltage and system fre-
quency conform to the voltage
and frequency shown on the
machine's rating label.
Protection against electric shock
by a residual current device
(RCD) of 30 mA sensivity.
Fuse protection of 16 A maximum
against short circuits.
System impedance Z
interconnection point
service connection) 0.35 Ohm
maximum.
3
Note:
Position power supply cable so it
does not interfere with the work and
is not damaged.
Protect power supply cable from heat,
aggressive liquids and sharp edges.
Use only rubber-jacketed extension
cables with sufficient lead cross-sec-
tion (see "Technical specifications").
Do not pull on power supply cable to
unplug.
B
Changing the direction of rota-
tion! (three-phase motors only)
Depending
sequence, it is possible the
saw blade will turn in the
wrong direction. This can lead
to the workpiece being hurled
away when attempting to make
a cut. The direction of rotation
must therefore be check every
time the saw is connected to
another outlet. In case of an
65
incorrect direction of rotation,
the wiring of the outlet must be
changed by a qualified electri-
cian:
installed,
a qualified electrician!
6.2 Installation
at the
max.
(house

7. Operation

A
Risk of injury!
This saw may only be operated
by one person at a time. Other per-
sons shall stay only at a distance to
the saw for the purpose of feeding or
removing stock.
Before starting work, check to see
that the following are in proper work-
ing order:
power cable and plug;
ON/OFF switch
riving knife
blade guard
feeding aids (push stick, push
block and handle).
Use personal protection gear:
on the phase
Assume proper operating position:
If the type of work requires, use the
following:
Avoid typical operator mistakes:
by
c
ropes, cords, strings, cables or wires
are attached or which contain such
materials.
7.1
A
(e.g. beech, oak, ash) can cause can-
cer when inhaled. Use a suitable dust
collector when working in enclosed
spaces The dust collector must meet
the following requirements:
dust respirator;
hearing protection;
safety goggles.
at the front of the saw;
in front of the saw;
to the left of the line of cut;
when working with two persons,
the other person must remain at
an adequate distance to the saw.
table extension, if otherwise
workpiece would fall off the table
after cutting;
sliding carriage;
dust collector.
Do not attempt to stop the saw
blade by pushing the workpiece
against its side. Risk of kickback.
Always hold the workpiece down
on the table and do not jam it.
Risk of kickback.
Never cut several workpieces at
the same time – and also no bun-
dles containing several individual
pieces. Risk of personal injury if
individual pieces are caught by
the saw blade uncontrolled.
Drawing-in/trapping hazard!
Never cut stock to which
Dust collector
Danger!
Dust of certain timber species
hoses must fit the outer diameter
of the dust extraction ports (blade
guard 36 mm; chip case 100 mm);
3
air flow volume 460 m
vacuum at dust extraction port of
saw 530 Pa;
air speed at dust extraction port
of saw 20 m/ s.
/h;