Initial Operation; Installation - Elektra Beckum UK 220 Operating Instructions Manual

16
17
Note:
Upon power failure an undervolt-
age relay is activated. This prevents the
starting of the machine when the power
is restored. To restart the saw after a
power failure the green switch button
(16) needs to be actuated again.
The ON/OFF switch can be blocked by a
padlock.
Handwheel for depth of cut setting
and pull action
The depth of cut can be adjusted by
turning the handwheel (18).
To actuate the pull action
Lift handwheel slightly = saw blade
can be moved lengthwise by pulling
on the handwheel.
When the handwheel is released the
saw blade returns automatically to
its rear rest position.
Pull action lock lever
To lock the pull action
Lever (19) to the left = pull action
enabled.
Lever (19) to the right = pull action
disabled.
Handwheel for blade tilt setting
With the handwheel the saw blade can
be steplessly tilted to the right from (20)
0 (vertical) through 45 .
The centre of motion is at saw table
level, so the depth of cut remains the
same, regardless of the bevel angle.
Ratchet lock lever
The set bevel angle can be locked with a
18
ratchet lock lever (21), so it does not
change during sawing.
Note:
There are several ratchet lock
levers on the saw. If the swivelling range
is not sufficient, the lever position can be
shifted:
pull lever up, turn and let engage again.
Lever, blade tilt limiter
The blade tilt setting has end stops at 0
and 45 . For special bevel cuts (under-
cutting) the bevel
increased by 1.5 in both directions.
Blade tilt limiter (22) left (down) =
saw blade bevel angle adjustable
between 0 and 45 .
19
Universal fence
The fence can be adjusted after loosen-
ing the wing nut (24).
20
The auxiliary fence extrusion can be
taken off and reversed after loosening
the two screws (23), (25):
21

7. Initial Operation

7.1
There are two ways to ensure a firm
stand of the machine:
angle can be
ENGLISH
Blade tilt limiter (22) right (up) = saw
blade bevel angle
between –1.5 and 46.5
22
0°-45°
-1,5°-46,5°
In radial pull mode the fence can be
used for mitre cuts:
23 24 25
In table saw mode the fence can be
used as rip fence:
Wide edge = for cutting thick work-
pieces (max. 65 mm).
Small edge =
for cutting thin workpieces
for bevel cuts (in table saw mode)
for mitre cuts (in radial pull saw
mode).

Installation

Installation on workstand
(optional accessory);
Installation on a solid table or work-
bench with solid top.
adjustable
15