HP Tc2110 - Server - 128 MB RAM Maintenance Manual page 37

Chapter 3
6. Remove the new DIMM from its container, handling the module by its edges.
Use only HP PC133 (133 MHz) unbuffered ECC SDRAM DIMMs.
CAUTION The DIMM should be left in the anti-static container or placed on an anti-static surface,
until you are ready to install it into the DIMM slot.
7. Spread the two retaining latches on the slot and align the notches on the DIMM with the keys on the
slot. See Figure 3-13.
8. Holding the DIMM at 90 degrees to the system board, press the DIMM fully into the slot until the
retaining latches close. See Figure 3-14.
If the latches do not close, the DIMM is not inserted correctly.
Figure 3-12. DIMM Locations on System Board
Figure 3-13. DIMM to Slot Alignment
Installing and Configuring
31