Paper holder ø102mm/Right insertion
1. Attach the cord holder on the outer side of paper holder. Fix it with M3 screw.
2. Insert the PNE sensor cable through the outlet in the main unit and plug in to the
connector.
3. Attach the paper holder into the hole (2) & (3) with M3 screws. Place the paper shaft
onto the holder hole and attach it in the uppermost hole with M4 screw.
4. Attach the shaft stopper through (1) hole in the main unit with M3 screw. Close the
main board with the M3 screws.
— 26 —