Attaching The Mounting Rails To Your Bicycle Seat - Burley DASH FM Owner's Instruction & Safety Manual

Attaching the Mounting Rails to Your Bicycle Seat

DASH FM
1. Remove the Mounting Rails from the Mounting Block by depressing the front face of the
Mounting Block [Figure 1a] and simultaneously pull the Mounting Rails out of the Mounting
Block [Figure 1b].
NOTE: Pull both Mounting Rails from Mounting Block at the same time for smooth removal.
2. Remove the Mounting Knob by lifting the Locking Ring up away from the Bicycle Seat [Figure
2a], and rotating the Mounting Knob counter-clockwise until detached [Figure 2b].
3. Flip the Base Plate away from the Bicycle Seat and remove it from the slots on the underside of
the Bicycle Seat [Figure 3].
4. Pass the Mounting Rails through the 2 holes between the legs of the Bicycle Seat [Figure 4].
NOTE: The orientation of the Mounting Rails should be such that they are bending downwards
[Figure 4].
5. For initial setup, align the Mounting Rails with position #3 on the underside of the Bicycle Seat
[Figure 5].
NOTE: These 3 positions are for adjusting the horizontal position of the Bicycle Seat. See
"Checking the Position of the Bicycle Seat" (Page 14) for further details.
6. Insert the metal Base Plate [Figure 6a] into the slots on the underside of the Bicycle Seat [Figure
6b], and flip it closed [Figure 6c] so that the bolt passes through the slot in the Base Plate.
7. Re-attach the Mounting Knob to the bolt on the underside of the Bicycle Seat by rotating it
clockwise [Figure 7a] until you cannot rotate it anymore.
NOTE: During the last few rotations of the Mounting Knob, the Locking Ring should make
audible clicking noises. When fully tightened, the Locking Ring should be preventing the
Mounting Knob from rotating counter-clockwise [Figure 7b].
CAUTION: This step is extremely important for the safety of the child.
8
ENG
CHILD BIKE SEAT