Mounting The Reflectors; Attaching The Wheels - Burley NOMAD Owner's Instruction And Safety Manual

Mounting the Reflectors
Nomad : The reflector brackets mount on the outside rear of each side
™
panel, 2.5" up from the plastic connector on the side panel. (The holes
for the mounting screws are covered by the fabric.)
To mount the bracket, insert a self-tapping bracket
screw through the hole in the curved section of the
reflector and drive the screw through the fabric,
into the hole in the rear side panel frame. (This
does not harm the fabric.) Then mount the reflector
onto the bracket with the reflector screw. Repeat for
the bracket and reflector on the other side panel.
See illustrations.
Flatbed : The reflectors are mounted to the reflector
™
brackets on the rear of the main frame tube. Snap
the posts on the reflectors into the openings in the
brackets, and with the provided screws, screw the
pieces together. Tighten the screws snugly, making
sure the reflector faces away from the trailer.

Attaching the Wheels

First, verify that the tires are inflated to 0-5 P.S.I.
Tip the trailer frame onto its rear end.
Nomad : With the quick-release lever in the "OPEN" position, insert the wheel
™
axle assembly completely into the hollow trailer axle, making sure that the
horizontal shaft goes all the way into the axle. Once the wheel is fully seated
in the hollow axle, position the quick-release lever so that it is aimed to the
rear of the trailer in the "CLOSED" position (the lever is marked for OPEN or
CLOSED positions). Repeat
for the other wheel.
6
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
2.5"
Right
rear