Installing The Tailgate And Splashguard (Nomad Only); Installing The Rollbar And Cover (Nomad Only) - Burley NOMAD Owner's Instruction And Safety Manual

All four side panel hold-downs must be snapped in place before using the
trailer. Otherwise, the side rails can shift or collapse, resulting in the loss of cargo.
Installing the Tailgate and Splashguard
Nomad : Thread the rear tie-down straps through the inner and then outer slots
™
of the male buckle sections of the rear side release buckles, which are
attached to the female buckle sec-
tions on the inside rear of the side
panels. Allow enough slack so you
can loop the webbing straps over
the rear of the side panels. To attach
the front splashguard to the front
of the side panels, repeat this step
using the front tie-down straps and
the front side release buckles. To ac-
commodate different sizes of cargo,
tighten or loosen the webbing straps
as required (see illustration).
Installing the Roll Bar
and Cover
Nomad : Place the cover, right side
™
out, over the side rails with the "Nomad" logo at the front of the trailer. Slip
a roll bar knob through one of the grommets on the cover. Slide the roll bar
8
B U R L E Y T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
WARNING
Tailgate
Trailer Frame
through the casing in the top of the
mesh divider. Align one end of the roll
bar with its corresponding hole on
the side rail. Thread the roll bar knob
through one side rail, and tighten
it into the roll bar (see illustration).
Repeat this step for the roll bar knob
on the other side. Pull the B-tabs down
and loop the rubber O-rings over the
trailer frame. Make sure the cover
extends over the top of each side
panel.
B-tab
Splashguard