Using Computer Setup (F10) Utilities - HP Elite 7500 Microtower Maintenance And Service Manual

●
Solve system configuration errors detected but not automatically fixed during the Power-On Self-
Test (POST).
●
Replicate the system setup by saving system configuration information on a USB device and
restoring it on one or more computers.
●
Execute self-tests on a specified ATA hard drive (when supported by drive).
●
Enable or disable DriveLock security (when supported by drive).

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system.
To access the Computer Setup Utilities menu, complete the following steps:
1. Turn on or restart the computer. If you are in Microsoft Windows, click Start > Shut Down >
Restart.
2. Press either
the bottom of the screen.
Pressing
NOTE:
and again press
3. If you pressed Esc, press
4. A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security,
Power, and Advanced.
5. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and
down) keys to select the option you want, then press Enter. To return to the Computer Setup
Utilities menu, press Esc.
6. To apply and save changes, select File > Save Changes and Exit.
●
If you have made changes that you do not want applied, select Ignore Changes and Exit.
●
To reset to factory settings or previously saved default settings (some models), select
Apply Defaults and Exit. This option will restore the original factory system defaults.
CAUTION:
(F10) changes because the CMOS could become corrupted. It is safe to turn off the computer only
after exiting the F10 Setup screen.
Table 3-1 Computer Setup (F10) Utility
Heading
File
Storage
Security
Power
Advanced
Esc or F10 while the "Press the ESC key for Startup Menu" message is displayed at
Esc displays a menu that allows you to access different options available at startup.
If you do not press Esc
Esc or F10 when the monitor light turns green to access the utility.
F10 to enter Computer Setup.
Do NOT turn the computer power OFF while the BIOS is saving the Computer Setup
or F10 at the appropriate time, you must restart the computer
Table
Computer Setup—File on page 8
Computer Setup—Storage on page 9
Computer Setup—Security on page 11
Computer Setup—Power on page 14
Computer Setup—Advanced on page 15
Computer Setup (F10) Utilities 7