Lifeline Configuration; Relay To Pstn - ZyXEL Communications Prestige 2602RL-D3A Support Notes

Table of Contents

Prestige 2602RL-D3A Support Notes

This can be applied on the emergency situation such as for contacting police, fire or emergency medical

services when is powerless situation. On the following section, it tells you how to configure lifeline under

P2602RL – D3A WEB GUI.

Lifeline configuration

To configure lifeline in P2602RL – D3A, click on VoIP -> PSTN Line to display the following screen.

You can specify a prefix number in prefix field. This number will be used to switch from VoIP to PSTN

system when you wish to make a call to PSTN destination. For example, when you want to dial out to a PSTN

destination, you first pick up the phone, and you will heard a dial tone, than you push in the prefix number as

defined in prefix field in this case it will be 0000, than the device will switch over to PSTN line. At this

moment you will hear dial tone from PSTN again. At this state you can dial out to PSTN as you would on a

regular PSTN system.

The Relay to PSTN field can be found under PSTN configuration WEB GUI in Relay to PSTN section. This

field is used to specify phone numbers to which the Prestige will always send calls through the regular PSTN

phone service without pushing prefix. In other words, numbers which specify on this field do not need to dial

prefix number to be dialed out. However, these numbers must be for phones on the PSTN (not VOIP phones)

and currently, P2602RL –D3A support up to nine entries under this field.

Table of Contents