Fitting The Front Moulding; Fitting The Adjustable Feet - Caple GR1201 Gastron Instruction Manual

Instructions for the installer
3.2

Fitting the front moulding

For the 70 cm model with double oven, a front moulding is included as standard supply to
complete the aesthetic lines of the cooker.
Before turning the cooker over, we recommend removing all the parts that are not stably attached
to it, in particular the cooking hob grids and burners. To lighten the weight of the cooker, the
accessories inside the oven may also be removed, thereby preventing accidental damage during
the overturning operation.
To assemble, proceed as follows:
Tilt the cooker backwards.
Align the moulding A with the mounting position as shown in the illustration.
Apply the moulding until it fits into the mounting position.
Pull the moulding downward so that it hooks onto the 4 pins B (2 for each end) present on the
cooker.
3.3

Fitting the adjustable feet

Before turning the cooker over, we recommend removing all the parts that are not stably attached
to it, in particular the cooking hob grids and burners. To lighten the weight of the cooker, the
accessories inside the oven may also be removed, thereby preventing accidental damage during
the overturning operation.
The cooker is delivered with the feet removed. Before moving and hooking up the cooker, take the
feet from the packing and screw them onto the cooker. This can be done in one of two ways:
A Lifting the cooker off the floor.
B Laying the cooker on its back.
The final regulation of the feet to level the
cooker to the floor will be done after the
gas and electric hook-ups have been
made.
Should it be necessary to drag the cooker, screw the feet in completely and carry out the final
regulation only when the other operations are completed.
9