Table of Contents
Advertisement
Any grease deposits on the vitroceramic hob
can be removed more easily by heating it for
approximately 20-30 minutes (knob in
position 11). Afterwards, this residue can be
cleaned off with a wooden spatula. Allow the
surface to cool, rinse with water and dry well
with a clean cloth.
In the event that aluminium or plastic marks, sugar or food containing sugar melt on the cooking
surface, remove immediately while the surface is still warm with a wooden spatula. This will
prevent any damage to the surface.
The cooking surface of the vitroceramic hob is extremely resistant. It is not however unbreakable
and may be damaged, above all by pointed or hard objects if dropped onto it with a certain force.
Warning! If any crack should appear on the hob, isolate the cooker from the main supply
and do not use the appliance to avoid electrocution. Call Customer Services immediately.
13.10 Cleaning the oven
In order to preserve the oven well, it should be cleaned regularly, each time it is used if possible,
after leaving it to cool: in this way it is possible to remove any residue more easily, preventing it
from burning the next time the oven is used.
Clean the stainless steel parts and enamelled parts as described in the corresponding sections
"13.1 Cleaning stainless steel surfaces" and "13.2 Cleaning enamelled surfaces".
Take out all the removable parts and wash them separately. Rinse and dry thoroughly with a clean
cloth.
13.10.1
Never use detergent products to clean this type of oven.
The walls of the oven can be cleaned using white vinegar and wiped with a cloth dampened with
water. Subsequently, heat the oven for at least one hour at 150°C to facilitate cleaning. When the
oven has cooled, wipe it again with a damp cloth.
13.10.2
We recommend always keeping the oven door clean. Use kitchen roll and on tougher dirt use a
damp cloth and household detergent.
Spray products for cleaning the oven must not be used to clean the fan and the thermostat
sensor inside the oven compartment.
13.11 Replacing the oven light bulb
Before carrying out maintenance, switch off the power supply to the appliance.
Proceed as follows:
42
Instructions for the user
Cleaning the oven walls
Cleaning the oven door
open the oven door;
unscrew the glass safety cap anticlockwise; unscrew the bulb and
replace it with another one for high temperatures (300°C) with the
following characteristics:
Voltage:
230 V / 50 Hz
Power:
15 W
Attachment:
E 14
Refit the glass cap and switch on the power. It is possible to check that the oven light is
working even when the door is closed by turning the function switch knob to position
.
Advertisement
Table of Contents
