When Using a Hard Disk (Only When a Hard Disk is Installed)
When using the optional hard disk, turn the printer OFF using the following
procedure.
IMPORTANT
If you perform a shutdown when any job of which you stopped the operation or of
•
secured print is in the hard disk, the message <
If you want to execute a shutdown, perform a soft reset to delete the job, and then
perform a shutdown again.
If you do not want to execute a shutdown, press [
Once you perform a shutdown, you cannot cancel the operation in midstream. When you
•
want to turn the printer ON again, turn the printer OFF once following the instruction of
the message, and then turn the printer ON.
NOTE
You can also perform <
control panel.
1
Make sure that the
2
Hold down the control panel power switch (sub power supply)
on the control panel until <
displayed, then release the switch.
Hold down the switch (approximately 4 seconds) until <
is displayed. If the switch is released in less than 4 seconds, and <
is set to a setting value other than <
Mode.
6
> is displayed.
> in the
menu by pressing [
indicator and HDD indicator are off.
Off
>, the printer enters Power Save
> or <
].
] on the
> is
>
>