Table of Contents
Advertisement
Continuation of "If a packing material is
provided"
g
Remove the tape (1 piece) shown in the
figure.
h
Proceed to Step 4.
4
Hold the drum cartridge by the blue tabs (A) and shake it up
and down 10 to 12 times each as shown in the figure to evenly
distribute the developer inside the cartridge.
Hold the blue tabs of the drum cartridge.
Shake the drum cartridge up and down 10 to 12 times each as shown in the
figure.
IMPORTANT
If the developer is not distributed evenly, this may result in deterioration in print
quality. Be sure to carry out this procedure properly.
Continuation of "If tape is provided"
g
Remove the tape (3 pieces) shown in the
figure in order of a and b.
The tape to be removed in
attached to the rear end. Remove them together.
Remove this tape also.
a
b
h
Proceed to Step 4.
(A)
b
has another tape
(A)
127
Advertisement
Table of Contents
